Home > EtherChannel Questions 6

EtherChannel Questions 6

November 22nd, 2019 Go to comments

Question 1

Explanation

EtherChannel load balancing can use MAC addresses, IP addresses, or Layer 4 port numbers

Question 2

Explanation

This question wants to mention about the “errdisable recovery cause channel-misconfig” command, which is used to recover from Etherchannel misconfig.

Question 3

Question 4

Question 5

Comments
  1. polleke
    January 10th, 2020

    Q4 Which two statements about configuring EtherChannel are true?
    Answer E is wrong since L2 are not called packets, but frames…..

  2. Q5
    January 17th, 2020

    Correct answer is D

    Auto —Enables PAgP only if a PAgP device is detected. It places the port into a passive negotiating state, in which the port responds to PAgP packets it receives but does not start PAgP packet negotiation. This keyword is not supported when EtherChannel members are from different switches in the switch stack.

  3. Anonymous
    January 23rd, 2020

    {email not allowed} please sent dump

  1. No trackbacks yet.